Face Milling
Face Milling
Get complete details of Face Milling products in our E-catalog
SEKT1204[4E]
A highly positive rake insert, it comes with high repeatability and low cutting stresses. Ideally suited for finish to medium applications. Should be 1st choice for low power machines.
SEMT1204AFTN-GM
ONMU060408[16E]
16 cutting edges for the highest economy in face milling. Suited for finish to semi-finishing applications of Ap ≤ 3mm on Steels & cast irons.
Two chip geometries offered
(i) GL, sharp chip geometry for low stress machining and semi-finishing of Steels, Irons & Stainless Steels &
(ii) GM, tough chip geometry suited for high stress medium milling applications.
-GM
-GL
SNMU1206 ANEN, ZNEN, CR1.2, CR1.6 & CR2.0 – GM [8E]
The design of the SNMU1206 series embodies interoperability with most if not all suitable for 45° & 88° approach angle milling. The addition of various corner radii makes it simple for a machine shop to use 1 insert for all their face milling (& other milling) needs.
- The -GM chip geometry offers a tough geometry with sufficient sharpness to achieve medium finishing requirements and suits almost all material classes.
- It comes with a host of grades which also are interoperable. Meaning, 1 grade can work across material classes.
HNMU1107ZNN-GH [12E]
Large IC insert with 12 edges and strong chip-geometry for heavy milling applications in a variety of materials. Most suited to Steels & cast irons with partial suitability to Stainless Steels.
HNMU-GH
SNMU1506ANSN-GH [8E]
Very strong insert with approach 45° for heavy milling applications in all materials. Special chip geometry for withstanding high cutting stresses. Very high impact resistance.
